Infinity By The Numbers.

With its all-metal construction, Infinity stands apart as the only modular push-connect system that meets the technical test requirements and standards of ANSI B31.1, and offers a safe working pressure of up to 15 bar (220 psi).

Materials of Construction

Fittings

Usable Fluids

Pressure

Temperature

Resistance

Standards

Fire Resistance

Salt Water Spray Testing

Flow Capacities

Fittings

• Bodies & nuts brass, OT UNI EN 12165 CW 617 N
• Safety ring: TECHNOPOLMERIC
• Clamping washer: INOX AISI 304
• O-Ring: NBR DIN 3535/2 (high nitrile)

Usable Fluids

• Compressed air
• Vacuum
• Inert gas (nitrogen/argon)

Pressure

• -0.99 to 15 BAR
• -29.6 to 220 psi

Temperature

• Minimum -20º C to maximum 80º C
• Minimum -4º F to maximum 176º F

Resistance

• Mineral and synthetic compressor lubricants
• Ultraviolet rays
• Environmental weather conditions
• Mechanical shocks

Standards

Burst and Leak Testing

• ANSI B31.1 American National Standards Institute for power piping systems.
• NORMA UNI-EN 1254-2:2000 # 5.6

Tensile Test

• NORMA UNI-EN 1254-2:2000

Temperature Directive

• 97/23/CE Art 3.3 (Pressure equipment directive)

Fire Resistance

All Infinity components are non-flammable and will not propagate flame.

Salt Water Spray Testing

Conducted to ASTM B117-03.

Flow Capacities

Flow rates are based on a 1psi pressure drop per 100 ft. of pipe with couplings in a “straight line,” and measured at standard atmospheric conditions: 1013 mbar (14.7 psi) at 20 C – (68 F).

NOTE: For loop systems, flow rates can be doubled. Also, it is vital that the pipe size between the compressors and the loop system’s connection can accommodate the full capacity of the combined compressor output.

For more detail, refer to the chart below.

For best results, compare chart to compressor manufacturer’s equipment flow rates/sizes. Always select a pipe size that allows for future system expansion. The chart above allows for a minimum 15% expansion increase.